![]() Reader assembly orientation to be as shown on page 3 in Figure A.Ħ. Connect cables for Insync RAC as per page 4 of this documentĥ. Install the gang box with proper screws, not providedĤ. Carefully remove reader assembly (item #4) (see warning above) remove protective film from reader faceģ. Remove screws (item #1) to gain access to reader assembly (item #4)Ģ. Install reader (item #2) then faceplate (item #3) using screws (item #1)ġ. Connect cables for Insync RAC as per page 4 of this documentĤ. Install the drywall bracket on the wallģ. Remove screws (item #1) to remove reader assembly (item #2) from bracketĢ. InSync Wall Reader Instructions - (Flush Mount)ġ. InSync Wall Reader Instructions - (Gang Box Mount) IMPORTANT: The jumper cables supplied with the reader must be connected as shown in Figure B and Table 1 for the Table 1: Insync RAC and Wall Reader Connections Note: Jumper cables as shown in Figure B must be connected for the reader to operate correctly With the included screw (item #1), tightened at the bottom of the reader Hook the top of the reader enclosure (item #2) onto the top of the mounting plate (item #3) and secure together Connect cables for Insync RAC as per page 4 of this documentģ. The 1/2" steel screws for mounting on a metal frameĢ. Use the 1 1/4" wood screws and inserts for drywall, or use Plate of the reader to the wall using the screws provided. Pull cable(s) for RAC through hole in the back plate and, if applicable, through the gasket then screw the mounting Per column “Reader Connection” in table 1 or as per Figure Aġ. Route the other end of the wire through the hole in the mounting plate to the back of the reader and connect as Route the wire to the Insync RAC enclosure and connect to the controller board as per the column “RAC ReaderĬonnection” in table 1, or as per Figure Bģ. ![]() Use drilling template provided to prepare surface for installationĢ. InSync Wall Reader Instructions - (Surface Mount)ġ. Insync Wall Reader Instructions - (All Models) L’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) ![]() Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. Including interference that may cause undesired operation of the device.” Two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, “This device complies with Industry Canada licence-exempt RSS standard(s). Interference that may cause undesired operation.Īny changes or modifications of this product, not approved by manufacturer will void the user’s authority to operate Operation is subject to the following two conditions: (1) thisĭevice may not cause harmful interf erence, and (2) this device must accept any interference received, including This device complies with Part 15 of the FCC Rules. The reader also provides visual feedback when The reader has a blue LED that indicates that the unit is powered. The reader is capable of functioning up to distances of 500 feet (152.4 m) when It is made from durable materials and comes with at The RFID wall mounted reader provided by dormakaba is compact, lightweight, rugged and water resistant, able to *CAUTION* Wear Safety Glasses While Preparing Wall InSync Wall Reader Instructions - (All Models)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |